Personal Protective Equipment

What to Look for in Foot Protection

OSHA says that It’s your job to make sure employees use foot protection when there is a danger of foot injuries. That makes selecting the right protection for the hazard a priority.

OSHA’s general industry foot protection standard (29 CFR 1910.136) says:

“The employer shall ensure that each affected employee uses protective footwear when working in areas where there is a danger of foot injuries due to falling or rolling objects, or objects piercing the sole, and where such employee’s feet are exposed to electrical hazards.”

OSHA also requires foot protection to be designed to comply with any of the following consensus standards:

  • ASTM F-2412-2005, “Standard Test Methods for Foot Protection,” and ASTM F-2413-2005, “Standard Specification for Performance Requirements for Protective Footwear,” which are incorporated by reference in § 1910.6;
  • ANSI Z41-1999, “American National Standard for Personal Protection — Protective Footwear,” which is incorporated by reference in § 1910.6; or
  • ANSI Z41-1991, “American National Standard for Personal Protection — Protective Footwear,” which is incorporated by reference in § 1910.6.

In addition, safety footwear manufacturers provide tags and labels that inform you of the footwear’s intended purpose. For example, the tag might indicate that the footwear is slip resistant, protects from falling objects, or protects from electrical hazards. It is dangerous to assume that a shoe will also protect against a hazard that is not specifically identified on a tag.


All the safety training you need in one program: 25 subjects, one low price. It’s BLR’s Safety Training Presentations. Try it out and get a Free Special Report. Get the details.


Key Selection Issues

  • Just like everyday footwear, when selecting work shoes it is important that they fit properly and are comfortable, especially if workers are going to spend 8 to 12 hours a day in them. Lightweight footwear, for example, will reduce fatigue.
  • When fitting footwear, employees should make sure boots fit snugly around the heel and ankle when laced up. But they should leave plenty of wiggle room for toes. It’s best for workers to try on work shoes after a work shift when feet are likely to be swollen to their maximum size.
  • Shoes that don’t fit properly could contribute to musculoskeletal disorders such as plantar fasciitis and heel pain from heavy heel impact and chronic stress in the heel area. Ankle, knee, and possible low back pain are also common when there is excessive strain on the weight-bearing skeletal system.
  • All sorts of insoles are available on the market today. But soft, cushion, and gel insoles only provide short-term relief. Because they are soft, these products cannot stabilize the foot and just collapse as the foot and ankle go through their normal range of motion. They do not provide the needed support.
  • Prefabricated over-the-counter orthotics can be purchased for a reasonable price. They support and control the normal collapse of the foot. They can provide the arch support that is needed but might be missing in many types of foot protection.

Try Safety Training Presentations at no cost and no risk. For a limited time, also get a Free Special Report! Find out more.


Training for Consistent Compliance

If you’ve been looking for quality safety training, including PPE training, look no farther. Safety Training Presentations gets you off to a good start with 25 core PowerPoint® safety presentations, each one responsive to either an OSHA training requirement or to common causes of workplace accidents. All are customizable, so you can add your specific hazards or safety policies.

Each lesson also includes completion certificates, sign-in sheets, evaluation forms, and training records. In short, it contains everything you need to motivate, reinforce, retain, and transfer new knowledge—and document that you did so.

Safety Training Presentations topics covered include:

—Bloodborne Pathogens
—Back Safety
—Emergency Action
—Ergonomics
—Fire Prevention
—PPE
—Welding/Cutting/Brazing
—Portable Power Tool Safety
—Scaffolds
—Lockout/Tagout
—Forklift Operator Safety
—Confined Space Safety
—Fall Protection
—Respiratory Protection
—and more!

Of course, training needs change as OSHA introduces new requirements or as new work practices and technologies bring new hazards. To cover this, you receive a new CD every 90 days you’re in the program, each containing five additional or updated topics.

Just as important for those on a budget (and who isn’t these days?), the cost of these presentations works out to under $20 each.

We’ve arranged for Advisor subscribers to get a no-cost, no-obligation look at Safety Training Presentations for 30 days. Feel free to try a few lessons with your own trainees. Please let us know, and we’ll be glad to set it up.

Print

1 thought on “What to Look for in Foot Protection”

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.